Hosting or Traveling for the Holidays? An HVAC Checklist for Van Buren, AR Homes

Thanksgiving is a few weeks out, and in Van Buren that usually means one of two things: a house full of family, or a car loaded up for somebody else’s house. Either way, the heating system has a different job than usual. A packed house with the oven running all day is one kind of load. An empty house during a late-November cold front is another. A few minutes of prep before the holidays heads off the two calls we hate getting most: a furnace that quits with twenty people coming, and a house that got cold while nobody was home.

Here’s a checklist for both.

If You’re Hosting

Change the filter a week before. More people means more dust, more traffic through the door, and often a few extra pets. A fresh filter keeps air moving and keeps the blower from working harder than it has to. If you’ve got a thick media filter, check it anyway.

Run the heat before the big day. If you haven’t run the furnace much yet this fall, run it for a full cycle or two a few days ahead. That burns off the first-of-season dust smell and gives you time to notice a problem while there’s still room on the schedule.

Open the guest rooms. Bedrooms that stay shut all fall with the vents closed get cold and stuffy. Open the vents and the doors a day or two before guests arrive so those rooms catch up. Closing vents in unused rooms doesn’t save as much as people think anyway, and too many closed vents can make the system strain.

Don’t fight the kitchen. A full oven, a stovetop going, and a crowd in one room will warm the house up fast. Rather than cranking the thermostat down to fight it, nudge it down a degree or two once dinner gets going. If the thermostat sits near the kitchen or in direct sun, it may think the whole house is warmer than it is.

Keep returns clear. Extra chairs, folding tables, and coats get stacked in front of return grilles every holiday. Blocked returns starve the furnace of air.

Check the carbon monoxide detectors. With a gas furnace, gas stove, and maybe a fireplace all going at once, working CO detectors near the bedrooms are a must. Press the test button now.

If You’re Traveling

Don’t turn the heat off. A late-November or December cold front can drop Van Buren into the teens overnight. A house with the heat off can get cold enough to freeze pipes on outside walls or in a crawlspace. For most homes, setting the thermostat somewhere in the mid-fifties while you’re gone is a reasonable middle ground. If you have pipes in an exterior wall that have frozen before, go a little warmer.

Set it and check it. If you have a smart thermostat, set it to an away schedule and make sure you can see it from your phone. That way you’ll know if the house starts dropping. If your thermostat isn’t connected, consider having a neighbor peek in if you’ll be gone more than a few days.

Heat pumps get a small setback. If you heat with a heat pump, a big drop in temperature while you’re gone isn’t the problem, but coming home and cranking it way back up can make the backup strips run hard. Turn it back up a few degrees at a time, or schedule it to come up the day before you get home.

Swap the batteries. A thermostat with dying batteries can go blank and stop calling for heat. If yours takes batteries, put fresh ones in before you leave.

Help the plumbing. Open the cabinet doors under sinks on outside walls, disconnect garden hoses, and make sure crawlspace vents or covers are closed for winter. These cost nothing and save a lot of trouble.

Look at the outdoor unit. If you have a heat pump, clear leaves away from it and make sure nothing is leaning against it. It needs airflow all winter.

Before Any of That: A Fall Check

If your furnace or heat pump hasn’t been looked at this year, the weeks before Thanksgiving are a good time. It’s still before the real cold, and the schedule is easier to work with than the week of a hard freeze.

🛠 What we do: a fall heating check covers the ignitor, flame sensor, burners, blower, electrical connections, thermostat operation, and a carbon monoxide test at the furnace. On heat pumps we check the defrost operation and the backup heat. If something’s weak, you’ll know about it before the family arrives, not during dinner.

If Something Goes Wrong

If the furnace quits while you have a house full of people, check the simple things first: the thermostat is set to heat and has power, the furnace switch is on, the filter isn’t packed solid, and the breaker hasn’t tripped. If it’s still not running, give us a call. Our office hours are weekdays, and we do take emergency calls outside of them; after-hours work is billed at an overtime rate, and we’ll quote it before we head out.

Do I need to leave the heat on if nobody is home?

Yes. Leaving the heat on low protects the pipes and keeps the house from getting damp and cold.

Do I need a smart thermostat to travel?

No, but it helps. Being able to check the temperature from your phone takes the worry out of a cold snap while you’re away.

Do I need to close vents in rooms we’re not using?

Generally no. Closing too many vents can make the system work harder and may cause other problems. Close a door if you’d like, but leave the vents mostly open.

Ready for a Full House in Van Buren

Clark HVAC is a family-owned, licensed and insured heating and cooling company, and we service furnaces, heat pumps, and thermostats in Van Buren and across Crawford County. Whether you’re hosting or heading out of town, we’ll make sure your heat is ready, and we’ll be straight with you about anything we find.

📞 Call Now: 918-839-3734

Straight answers. Fair pricing. Clean work.

Previous
Previous

Carbon Monoxide and Your Furnace: Questions Poteau, OK Homeowners Ask Us

Next
Next

Repair or Replace Your Furnace This Winter? A Muldrow, OK Decision Guide